My Favorite Guides
Questions
-
Special Eccentric Adjustment Spanner.I believe you now send out a special spanner for the eccentrics adjustment. I have a Ooznest Workbee V1 screw? Will it fit...
Answers
-
Answer to "Connecting to controller without internet"Let the Duet Controller send the Wi-Fi signal as an Access Point? This may help? 2. Connecting your Duet to a Network - Access Point
-
Answer to "Workbee not executing code correctly"Shouldn't you be using the Ooznest Duet Arcs (mm) (*.gcode) post-processor?
-
Answer to "How to pause workbee so can change the tool for finishing pass"And reset the Z zero after each tool change. ;o)
-
Answer to "Workbee Z1 Assembly Guide"If you open the chapter that you want, click on the 3 dots upper right, then you can save as a PDF.
-
Answer to "new duet 2 wifi controller which guide do I use"Brian, instead of putting http://workbee.local/ , try putting the IP address that you got from YAT into the address bar.
-
Answer to "What is the purpose of the Calibration Endmill?"Oooooh!! What dastardly deeds are afoot at Ooznest?
-
Answer to "My round holes are not coming round"Did you calibrate your x, y, z-axis? If not, this may help https://www.youtube.com/watch?v=PsCiCDZe...
-
Answer to "Instruction pictures not loading"Seems rectified now!
-
Answer to "Changing z during job"Step 5 of this guide allows for altering Z height if you are using Workbee Control. Not sure if you can do it during a run though, as not at my CNC. WorkBee Control Overview
-
Answer to "Is the "Stop Button" available as an upgrade?"Most Emergency Stop buttons will work. I did mine this way… How To Connect A Software Emergency Stop Button
Reputation over time
Reputation Breakdown
| Event | Count | Delta |
|---|---|---|
| Post was voted up | 7 | 84 |
| Accepted answer | 1 | 10 |
22